When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
FAST DELIVERY 30 DAYS RETURN100% CUSTOMER SATISFACTION58hrc Damascus Steel Blade Billets Diy Knife Making Raw Material Blanks Bar Trea Product Name: DIY Blanks - Damascus SteelSpecifications:Material: Damascus steel
Length: Approximately 16cm (with a 1-3mm error)
Width: Approximately 3cm (with a 1-3mm error)
Thickness: Approximately 0.3cm (with a 0.1-0.2mm error)
Hardness: About HRC58
Finish: Flat grinding and simple acid cleaning
Pattern: Each side may vary slightly in thickness and pattern due to the forging process.
Usage Instructions:Polish the rough steel or knife semi-finished product to 600# or above, preferably to a semi-mirror state.
Place the product in an acid pickling solution for about 1 minute.
Repeat the process if deeper pickling is desired, ensuring to neutralize the surface with detergent afterward.
Polish, polish, and oil the product for maintenance as required.
Notes:It\'s recommended to seal the product when not in use to prevent dissolution.
For optimal pickling results, use a water mixing ratio of 1:4, adjusting as needed based on the material and pickling intensity.
The pickling process may vary depending on the material and requirements. Contact customer service for specific instructions.REVIEWSThe product came very well packaged.
I\'m very happy. thank you for everything.
Seller strongly recommended.This is great! I definitely recommend! Product looks amazingDelivery was fast. Excellent seller, great communication. I advise everyone