VPO 64 Input Keyboard and Stop Action Midi Encoder and Controller for Hauptwerk For Sale

With the increasing interest in Virtual Pipe Organs, the new MIPC-1A 64 Input to Midi Encoder is the ideal answer to keyboard and stop action wiring. The new controller card, is for the most part, Plug-N-Play requiring very little setup. Mount the card in the console, connect 8 to 15 volts DC, Midi IN and Midi OUT cables, and simple single contact wire wiring from key to the controller card. No Diodes or Matrix wiring required. Simple DIP SWITCH selection for the Midi Channel, Keyboard/Stop Action Mode and Swell Shoe selection. No programming or software code writing required. The MIPC-1 is best solution for building or converting a console to VPO.
Featuring

• 64 Inputs Direct Wiring Inputs, No Diodes or Metrex Wiring..
• Microprocessor Controller
• Crystal Controlled CPU
• DIP Switch Selectable Midi Channels 1 to 16
• DIP Switch Selection of Keyboard with starting midi note 36 or Stop Action with starting midi note of 0
• DIP Switch Selectable Midi note 0-63 or 64 to 128 In Stop Action Mode.
• DIP Switch Selection for up to 4 Swell Shoes.
• No Programming
• Midi IN and Midi OUT Jacks
• 8 to 15 Volt DC operation
• Pull to Ground Output Switching, coil commons are connected to Plus Voltage
• Low operating current, 12 ma. per card
• 6.3" long x 2.8" wide
• Connector option, 34 Pin Ribbon connectors or Molex KK-100 Series connectors.
  
• Easy Setup in Hauptwerk
•