When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Left sided border panel is great for large window or slider. It’s 64” w x 96” L ”
64” pinch pleat top width x 150” bottom width when fabric is fully measured across from the 3 fabric panels of 100 % cotton drapery fabric.
4” of space between each top pleat and 92” below pleats for 96”.
Left sided border panel only. It’s 64” w x 96” L ”
professionally made with flannel insulation and off-white lining for black-out and guard from sun damage. 3 weights in each panel. Good Noise reduction, too. (There’s been some discoloration on lining that’s off-white- see photos)
They add a nice touch to any room. They’re quite large and after they’re pressed - they should look a lot better. They are boxed and ready to ship -
They’d retail new for $300+ : they have never been hung nor used. They were stored in heavy plastic for 2-3 years and the pinch pleats where the 15 hooks sat did incur some rust spots but it’s typical due to moisture that can cause this from metal hooks. (There are 8-9 hook spots that have some rust and it’s photographed)
They are made with 3 panels of a thicker flannel insulation with a lining overtop- these are weighted, too in 3 spots on the drapes. (The flannel is the bulk of the weight - they’re 10.6 lbs.
I’ve dropped them as low as it makes sense to do so . They will add value to any room and lower sound from outside (I’m in an apartment and there are noisy cars and I have a different panel up and not only did my heat go down $11 in January but it’s lessened the horrible noise) they are too big for a smaller apartment but it’s a great deal imo. They are heavy (10.5 lbs) because the flannel is probably about 6 lbs and it’s sheer on one side with nice thicker flannel on the other.
***They are being discounted because they are not “new” in the true sense and there are some minor issues, which are photographed and fully represented to the more extreme side so that I’m being as transparent as possible. I’ve scoured the drapes and found a 1” spot at the lower level bottom left corner and I tried to photograph but it’s extremely faint and I found it after looking several times, the other marks are 3 spots about a mm in size and there were 2 areas at the very bottom of the drapes. They are photographed in last 3-4 photos.
Also, a 1” tear in the back -photographed. Its easily closed up but I left it so it’s represented…It’s in the lining in the back and the pleat hooks I mentioned created some rust spots in about 7-8 sections so I photographed these, too.
They will need some attention so the price basically is below the fabric cost but they are absolutely fine and after adding hooks and a press they’re good to hang.
(The price is extremely low and I’m firm on it. They are folded over twice and ready to ship in 1 days. You’d have to spend $400 for newly made version and this panel has lots of years in it and will add value. A lot of drapes are thin, lightweight, mass produced and will not last past 6-7 years before looking poorly- these will hang for years and years. Remember they will need 15 pleat hooks of regular size and not small ones. )
ABOUT 
